MOGYKTTOL Installation Guides

After confirming the drawer box has enough space for installation:

• Remove the cutout template and determine the opening position.
• Position from the inside or back of the drawer box.
• Confirm that the outlet will not interfere with drawer slides.
• Leave enough material around the opening for secure fastening.

Note: Proper positioning is critical for smooth operation.

To create the cutout in the drawer box:

1. Use a 1/2 in drill bit to create a hole in each corner.
2. Protect the inner drawer face from splintering.
3. Insert a jigsaw into one of the corner holes.
4. Cut the opening slowly and precisely.

Caution: Work slowly to ensure a clean cut.

1. Reinsert the drawer box.
2. Slide the receptacle box through the cutout.
3. Position it correctly in the opening.
4. Ensure the box is flush with the drawer surface before securing.

1. Position the outlet in the receptacle box.
2. Align the screw holes with the mounting brackets.
3. Insert and tighten the outlet mounting screws.
4. Check that the outlet sits flush and does not wobble.

1. Align the cover with the outlet.
2. Press it firmly into place until it clicks.
3. Make sure all edges are fully seated.
4. Verify that the cover opens and closes smoothly.

1. Close the drawer most of the way.
2. Mark the rear mounting bracket position using the model dimensions.
3. Confirm the measurements are precise.
4. Verify that the drawer will move smoothly through its full travel.

1. Drill the marked mounting holes and secure the bracket.
2. Connect the power cable to an appropriate power source.
3. Test the outlet with a device.
4. Verify that the drawer opens and closes smoothly.

Your drawer outlet is now ready to use.